Fatbar36 Warnings

This product must be fitted by a qualified mechanic

Do not use this product following a crash, or if the product is damaged or marked in any way

Do not attempt to straighten bars if they become bent

Only fit this product using a calibrated torque wrench

Do not exceed 18Nm when tightening bar mounts

Exceeding 18Nm will damage the handlebar, if you exceed 18Nm Renthal recommend you replace the handlebar

Remove any burrs from contact edge of bar mount before Installation

It is essential that 36mm diameter bar mounts are used

Do not damage the handlebar during installation

After installation ensure steering is not disrupted

Renthal recommend the maximum torque of 18Nm to an M8 fastener on a bar mount with a width of 25mm

Do not modify the handlebars

Do not mark the handlebar. Physical marking of the handlebar will lead to stress raisers which could lead to a fatigue failure

Do not drill into or modify bars and bar mounts

Do not install after-market end plugs or handguards that mount using internal expanding end plugs

Do not remove end plugs

Do not modify 7/8” or 1-1/8” diameter bar mounts to fit 36mm diameter handlebars

Do not use the handlebar as a mounting point when transporting the motorcycle

Failure to comply with the warnings and installation instructions can result in complete product failure